GMC P30
-
GMC P30 1994
VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS, VANS AND MOTORHOMES EQUIPPED WITH ELECTRONICALLY FUEL INJECTED 6.5L DIESEL ENGINE. THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION PART 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. THE CAMPAIGN WILL IMPROVE THE OVERALL DRIVEABILITY OF THESE VEHICLES.
-
GMC P30 1986
LEFT HAND LOWER CONTROL ARM CAN CRACK AND COULD EVENTUALLY CAUSE THE LOWER BALL JOINT TO SEPARATE FROM THE CONTROL ARM.
-
GMC P30 1985
LEFT HAND LOWER CONTROL ARM CAN CRACK AND COULD EVENTUALLY CAUSE THE LOWER BALL JOINT TO SEPARATE FROM THE CONTROL ARM.
-
GMC P30 1982
IN A VEHICLE IMPACT FROM THE REAR, THE THREE PIECE HOSES COULD SEPARATE AND RESULT IN FUEL LEAKAGE IN EXCESS OF THE AMOUNT PERMITTED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, FUEL SYSTEM INTEGRITY.
-
GMC P30 1978
THE INTERMEDIATE SHAFT COUPLING ON THE INVOLVED VEHICLES MAY HAVE BEEN MACHINED OVERSIZED IN THE SERRATION AREA WHERE IT ATTACHES TO THE STEERING COLUMN. THIS WOULD PREVENT THE COUPLING FROM PROPERLY TIGHTENING ON THE SHAFT WHEN THE CLAMP AND PINCH BOLT WERE INSTALLED.
-
GMC P30 1975
THE FRONT SUSPENSION CONTROL ARMS WERE ASSEMBLED WITH BALL JOINTS WHICH MAY CONTAIN SOCKETS THAT WERE NOT PROPERLY HEAT-TREATED. THIS MAY CAUSE THE SOCKET TO WEAR RAPIDLY AND ALLOW THE BALL JOINT STUD TO SEPARATE FROM THE SOCKET, CAUSING EITHER THE LEFT OR RIGHT WHEEL SUSPENSION TO COLLAPSE.
-
GMC P30 1976
THE FRONT SUSPENSION CONTROL ARMS WERE ASSEMBLED WITH BALL JOINTS WHICH MAY CONTAIN SOCKETS THAT WERE NOT PROPERLY HEAT-TREATED. THIS MAY CAUSE THE SOCKET TO WEAR RAPIDLY AND ALLOW THE BALL JOINT STUD TO SEPARATE FROM THE SOCKET, CAUSING EITHER THE LEFT OR RIGHT WHEEL SUSPENSION TO COLLAPSE.
-
GMC P30 1975